I removed all of the components from the neGcon's board and soldered to the pads where the IC was..Originally Posted by JABBERJAW
http://i50.photobucket.com/albums/f3.../neGcon033.jpg
It doesn't look quite like this now internally, as all that wiring was removed and redone for the new cable, but it's still pretty much the same and the same spots used. Since it's a Common Ground layout the D-pad connections run right to the IC on the board, so if it's removed ya have access to the one side of them right there, then any Ground spot for the other. You could also trace back a bit and use a Via if ya were so inclined. The Start button has to be isolated, unless your controller also uses a Common Ground type of layout, the PS3 controllers do not as they have a weirdo 3 Common line type of setup.
Reply With Quote