PS3 NeGcon - Can it be done???

[BulletWraith]

(sorry guys this might sound like a lotta dribble for mosta you so you might not want to delve into this one)

I can't believe I Missed this thread, I've chalked up many ideas for a PS2(long time ago)/PS3 neGcon type controller to work with any game, me sucking at electronics(failed the half year I did of it at school) I tried swapping the potentiometer from the neGcon into the left sticks R/L pot
this didn't work to well at all
and since I bought a few broken DSII's to muck about with I cut one right down the middle and came to the conclusion that it was way more comfortable having swivelling DS then to use a neGcon (a harsh truth for me)

from what I can tell the DS3 board is pretty small, so I figure just move the board as far as you can inside the controller to the left so it's half sitting under the D-Pad then cut the DS3 in half but not straight down the middle, cut right down the centre of the of the Start button, in this cut will be transplanted the neGcon Swivel bit or what I'd do would be to try to jam in a Ball Bearing with the left sticks x-axis pot inside it in their

to me this seems allot easier than transplanting the innards into a neGcon, if I were to do a transplant I would probably be to lazy
I'd just rip out the innards from a sixaxis, cram them into a tiny black plastic box, strap that to my left wrist and wire all the inputs from the box into the neGcons cord
not very elegant but it would get the job done

-zer0shen out

(PS about the range of motion, I thought allot about that, two things: you could try and find a Pot with the same input range that has a great range of motion or use a couple cogs to lengthen out the motion)